CRENOL & WILSON

(WORKHOLDING ) LIMITED

Designers, Manufacturers and Suppliers of Quality Workholding and Toolholding Products

Vacuum Systems

VACUUM CLAMPING SYSTEM

  • Vacuum plate sizes from 250 x 125 x 51mm up to 1100 x 360 x 51mm
  • Ideal for both magnetic & non-magnetic parts
  • Difficult shaped components held easily & securely
  • For milling or grinding
  • Rotary vacuum pump easily portable – bulky air receiver not required.  Capacity of pump 4m3/h
  • Control unit with vacuum breaker & vacuum gauge
  • Vacuum pump 240 volts, 50 cycles, single phase – with on/off switch & water separator
  • Adjustable parallel end & side rails
  • Rubber seal cord is simply inserted into the vacuum plate grooves according to the workpiece contour
  • Vacuum plates with same dimensions & grooves are fully modular
  • Security switch for switching off machine tool in case of vacuum loss
  • Vacuum engraving plates also available
  • Very thin workpieces held without distortion – unlike when using double sided tape

Enquiry Form

Request a Chuck Jaw Catalogue